Stick Grips

I spent the day installing the Infinity stick grips. I had to make the hole in the side of the stick bigger to accommodate the cable. I also had to drill a hole in the adapter sleeve to secure it to the top of the stick.

Then the fun began. Sorting out all the wires. The copilot stick is slightly different than the pilot stick because I have a switch on the panel to disable most of the functions on that stick for when I have a non-pilot over there.

I had these same stick grips on my RV10 and liked them.

I can trim, flip flop comms, IDENT, raise and lower the flaps, disconnect the autopilot and PTT.

My Dad was very helpful when I was toning out all the individual wires.
8 hours.

Leave a Reply

Close Bitnami banner